Changing The Engine Oil - Toro 74310 Operator's Manual

Figure 32
1. Oil-fill cap

Changing the Engine Oil

Service Interval: Every 100 hours (more often in dirty or
dusty conditions).
Note: Dispose of the used oil at a recycling center.
1. Park the machine so that the rear is slightly lower than
the front to ensure that the oil drains completely.
2. Move the speed-control lever to the N
to stop the machine.
3. Disengage the PTO, engage the parking brake, shut off
the engine, and wait for all moving parts to stop.
2. Oil dipstick
position
EUTRAL
4. Slowly pour approximately 80% of the specified oil
into the filler tube and slowly add the additional oil to
bring it to the full mark on the dipstick
5. Start the engine and drive to a flat area. Check the oil
level again (Figure
6. If needed, add oil to the full mark on the dipstick.
34
Figure 33
(Figure
32).
32).