Advanced Setup; Common Procedures In Setup Menu; Speaker Setup - Onkyo 29344937 Instruction Manual

Advanced Setup

Common Procedures in Setup Menu

ENTER
SETUP
Number
Buttons

Speaker Setup

This section explains how to check the speaker settings and how to set them manually, which is useful if you change a
speaker after performing the Audyssey 2EQ™ Room Correction and Speaker Setup.
Some of the speaker settings are set automatically by the Audyssey 2EQ Room Correction and Speaker Setup function
(see page 46).
2-1. Sp Settings
See "Speaker Settings" on page 44.
2-2. Sp Config (Speaker Configuration)
With these settings, you can specify which speakers are connected and a crossover frequency for each speaker. Specify
"FullBand" for speakers that can output low frequency bass sounds adequately, for example, speakers with a good
sized woofer. For smaller speakers, specify a crossover frequency. Sounds below the crossover frequency will be
output by the subwoofer instead of the speaker. Refer to your speaker's manuals to determine the optimum crossover
frequencies.
Subwoofer
*1
Front
*2
Center
*2
Surr
*2*3*5*6
FrontH
*3*4*5*7
SurrBk
SurrBack ch
68
Remote
indicator
RECEIVER
qwer
Yes: Select if a subwoofer is connected (default).
No: Select if no subwoofer is connected.
FullBand, 40 Hz to 100 Hz (default), 120 Hz, 150 Hz, 200 Hz
FullBand, 40 Hz to 100 Hz, 120 Hz, 150 Hz, 200 Hz
None: Select if no speaker is connected.
*8 1ch: Select if only one surround back L speaker is connected.
2ch: Select if two (left and right) surround back speakers are connected (default).
1 Press the [RECEIVER] button followed by
the [SETUP] button.
2
Use the Up and Down [q]/[w] buttons to
select main menu, and then press
[ENTER].
3
Use the Up and Down [q]/[w] buttons to
select the function, and then press the
[ENTER] button.
4 Use the Up and Down [q]/[w] button to
select item, and then use the Left and
Right [e]/[r] buttons to set them.
5
When you've finished, press the [SETUP]
button.
Setup closes.
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.