Turning On The Av Receiver; Turning On And Standby - Onkyo 29344937 Instruction Manual

Turning On the AV receiver

ON/STANDBY
STANDBY indicator

Turning On and Standby

AV receiver
controller
or
Up and Running in a Few Easy Steps
To get your system up and running with the minimum of fuss, here's a few pointers to help you configure the AV
receiver before you use it for the very first time. These settings only need to be made once.
■ Do the 2EQ Room Correction and Speaker Setup—this is
essential!
See "Audyssey 2EQ™ Room Correction and Speaker Setup" on page 46.
■ Did you connect a component to an HDMI input,
component video input, or digital audio input?
If you did, see "HDMI Input Setup" on page 41, "Component Video
Input Setup" on page 42, or "Digital Input Setup" on page 43
respectively.
■ Did you connect a UP-A1 series Dock?
If you did, see "Connecting a Dock with the Universal Port
connector" on page 38.
40
On the AV receiver, press the [ON/STANDBY] button.
Remote
On the remote controller, press the [RECEIVER] button, followed by the
[ON/STANDBY] button.
The AV receiver comes on, the display lights up, and the STANDBY indicator goes off.
To turn the AV receiver off, press the [ON/STANDBY] button, or press the remote
controller's [ON/STANDBY] button. The AV receiver will enter Standby mode. To
prevent any loud surprises the next time you turn on the AV receiver, turn down the
volume before you turn it off.
ON/STANDBY
RECEIVER
Y
HDMI
P
B
P
R
UP-A1 series Dock
COAXIAL
OPTICAL