Drive System Maintenance; Checking The Tire Pressure; Adjusting The Tension Of Tine Drive Chains - Toro 23515 Operator's Manual

Figure 29
1. Fuel filter
5. Squeeze the ends of the hose clamps together and slide
them away from the filter (Figure 29).
6. Remove the filter from the fuel lines.
7. Install a new filter and move the hose clamps close to
the filter (Figure 29).
8. Remove the clamps from the fuel lines.
9. Open the fuel shutoff valve.
1
2
g017588
2. Fuel valve
Drive System
Maintenance

Checking the Tire Pressure

Service Interval: Every 50 hours
Maintain the air pressure in the tires as specified. Check the
tires when they are cold to get the most accurate reading.
Pressure: 83-97 kPa (12-14 psi)
1. Valve stem
Adjusting the Tension of Tine
Drive Chains
1. Raise the tines, stop the machine, stop the engine, and
disconnect the spark plug wire.
2. Raise the front of the machine to gain access to the
chains and block it in place.
CAUTION
If you do not securely block the up the front
of the machine, the machine could fall on you
during service, injuring you.
Ensure that you place a jackstand or block
under the front of the machine to hold it up
securely.
Important: Do not raise the rear of the machine.
Raising the rear of the machine will casue the
engine to flood and the air cleaner to be fouled
with gasoline.
3. Pull down on each chain near the opening in the frame
with 9 kg (20 pounds) of force (Figure 31). If a chain
flexes more than 3 mm (1/8 inch), tighten it as follows:
24
1
G003793
Figure 30