Specifications; Attachments/Accessories; Operation; Adjusting The Handle - Toro 23515 Operator's Manual

1. Tine-control lever—raised
position

Specifications

Length (handle in lowest
position)
Length (handle in middle
position)
Length (handle in highest
position)
Length (with handle stored)
Width
Height (handle in lowest
position)
Height (handle in middle
position)
Height (handle in highest
position)
Height (with handle stored)
Weight (as shipped with 2
weights)

Attachments/Accessories

A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
g013076
Figure 6
2. Tine-control
lever—lowered position
147 cm (58 inches)
150 cm (59 inches)
155 cm (61 inches)
107 cm (42 inches)
79 cm (31 inches)
122 cm (48 inches)
127 cm (50 inches)
132 cm (52 inches)
86 cm (34 inches)
172.4 kg (380 lb)

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.
1

Adjusting the Handle

The height of the handle can be adjusted for comfortable
operation. Stand behind the handle to determine the
appropriate height settings.
2
1. To adjust the handle height, position the hardware
into one of three sets of holes on each side of the
mainframe as shown in Figure 7, Figure 8, and Figure 9.
Front handle position — Lowest height
1. Trunnion bracket—bottom
hole
2. Lift link straps
11
Figure 7
3. Mounting bolt location
4. Handle hardware—front
holes