Table of Contents
Advertisement
Operating
Service Brake (Fig. 7)—Used to slow the traction opera-
tion.
Operating Instructions
STARTING/STOPPING ENGINE
1.
Make sure both wires are installed on the spark plugs.
2.
Make sure the traction drive is disengaged and the
gear shift lever is in Neutral.
3.
Pull the choke lever out to the ON position—when
starting a cold engine—and the throttle lever to the
mid position.
4.
Insert the key into the ignition switch and turn it
clockwise to start the engine. Release the key when
the engine starts. Gradually return the choke lever to
the OFF position (lever all the way in) after the
engine starts and warms up.
IMPORTANT: To prevent overheating of the
starter motor, do not the starter longer than 10 sec-
onds. After 10 seconds of continuous cranking,
wait 60 seconds before engaging the starter again.
5.
Make sure the coring head is in the raised position.
Note: When starting the engine for the first time, or
after engine, transmission or axle overhaul, operate
the machine in forward and reverse for one to two
minutes to be sure all parts operate correctly.
6.
To stop the engine, move the throttle control down-
ward to the SLOW position and turn the ignition key
to "OFF",
12
INSTALL THE TINES
1.
Start the engine: refer to Starting/Stopping instruc-
tions.
2.
Move the coring head lever to the "UP" position to
raise the coring head.
3.
Stop the engine and raise the lock-up brackets on
each side of the chassis (Fig. 8). Lower the coring
head until it rests on brackets.
1.
Lock-up bracket
4.
Loosen (2) hex nuts on each tine block until tines can
be inserted. Insert tines until they bottom out on the
flange in the tine block (Fig. 8).
Figure 8
Hide quick links:
Advertisement
Table of Contents
