Changing The Horizontal Position Of The Roller; Operating The Cultivator - Toro 23102 Operator's Manual

Changing the Horizontal
Position of the Roller
The roller has 3 horizontal positions. To cultivate along the
edge of the work area, align the edges of the roller with the
edges of the cultivator. To cultivate and area with no messy
edges between cultivation passes, offset the roller to either
side so that about 15 cm (6 inches) of the roller overlaps the
last cultivating pass.
1. Remove the drift pin
1. Snap-ring clevis pin
2. Drift pin
2. Slide the roller to the desired position
3. Insert the drift pin through the roller-support bar.
4. Insert the attached snap-ring clevis pin through the
drift pin to secure the roller.

Operating the Cultivator

1. Lower the cultivator to the ground and ensure that the
chain case is perpendicular to the ground
(Figure 8).
Figure 8
3. Roller-support bar
(Figure
(Figure
Figure 9
2. Pull the auxiliary-hydraulics lever to the operator grip
to start the cultivator.
3. Slowly lower the cultivator until the blades dig into the
soil and the roller touches the ground.
4. Slowly move rearward.
5. When the pass is finished, stop the hydraulics and raise
the cultivator.
Important: Do not drive the machine across pavement
or other hard surfaces without first raising the cultivator.
Crossing hard surfaces with the tines lowered damages
the tines and the property.
8).
9).
8