Override System - Toro GREENS AERATOR 09120 Operator's Manual

Note: Before coring head switch can be adjusted,
coring head drive belt must be correctly adjusted..
1. Traction switch
2. Mounting screws
6. If an adjustment to the switch is required, proceed as
follows:
A. Stop the engine and lower the coring head onto
the stand.
B. Remove the override pin from the storage brack-
et on the front of the coring head cover
(Fig. 16).
C. Push down on the override lever (Fig. 14) until
the holes in lever bracket and the coring bracket
are aligned, then insert the pin through the
holes.
D. Loosen the adjusting screw jam nut and (2)
flange nuts (Fig. 12).
E. Turn the ignition switch to the START position,
but do not start the engine.
F. While holding the ignition switch in the START
position, tighten the adjusting screw until the
engine cranks.
G. Release the ignition switch and tighten the
adjusting screw one more turn.
H. Tighten the adjusting screw jam nut and (2)
flange nuts.
Figure 14
I. Restart the engine and raise the coring head.
J. Stop the engine, remove the override pin and
reinstall it in the storage bracket.
K. Start the engine and check all modes of opera-
tion. The coring head should not run when on
coring head lock-up brackets.
1. Coring head switches
2. Adjusting screw & jam nut
3. Mounting screws

OVERRIDE SYSTEM

The coring head is equipped with a release mechanism
that allows the engine to be started when the coring head
is in the lowered position.
1. Remove override pin from storage bracket on front of
coring head cover (Fig. 16).
1. Override pin
Figure 15
Figure 16
Operating
15