Tool Assembly - Milwaukee 5327-21 Operator's Manual

To reduce the risk of injury, always unplug
tool before attaching or removing accessories
or making adjustments. Use only specifically
recommended accessories. Others may be
hazardous.
To reduce the risk of injury, always use a side
handle when using this tool. Always brace or
hold securely.
Adjusting the Side Handle
1. Loosen the side handle slightly by unscrewing it counter-
clockwise.
2. Rotate the side handle to the required angle.
3. Tighten the side handle securely.

TOOL ASSEMBLY

WARNING!
WARNING!
Installing Chisels
The 5327-21 Hammer uses hammer steel chisels with ROUND/HEX
shanks.
Chisel with ROUND/HEX shank
1. Insert the chisel into the nose of the tool. Make sure that the notch in
the shank faces up.
2. Push the chisel into tool until it locks.
3. Check to see that chisel is locked by tugging on it.
4. To remove chisels, pull bit release collar toward the rear of tool and
remove chisel.
NOTE: Use caution when handling hot chisels.
page 5