Mounting in a single hanging or sideways position .......... 7 Mounting in a multiple array or matrix setup ............ 8 Securing the Fixture ...................... 9 Connections ........................10 Connect to the X4 ATOM PSU .................. 1 0 Accessories ........................11 Atom Trussbar ........................ 1 1 Maintaining and Cleaning ..................12 Safety regulations ...................... 1 2...
GLP German Light Products 1 Description of Device 1. X4 Atom head (actively and passively cooled) 2. detachable and adjustable yoke / floor-stand Rear view: 3. Power & Signal input (XLR 4pin connect to Atom PSU only!) 4. Vent plug 5.
7. Repair, maintenance, and installation work shall be done by qualified or GLP certified staff only. You need to pay attention to the common rules of technology that are not explicitly mentioned in this manual.
GLP German Light Products Important Safety Information The X4 ATOM fixture from GLP is fitted with a plano-convex lens. This type of lens can act as a strong magnifying glass. If the rays from a strong light source (such as the sun or another lighting fixture) are directed towards the front of any of these fixtures, then internal damage may occur.
GLP German Light Products 3 Mounting The X4 ATOM is fully operational whether it hangs or is mounted to the wall. It can also be operated while standing on the floor. Keep a safety distance of min. 0.5 m towards any easily inflammable materials (decoration etc.).
GLP German Light Products 3.1 Operating on the Floor (Upright) The X4 ATOM can easily be fitted with the included floor-stand which allows a stable standing of the fixture. It is fixed to the Atom head by simply sliding it into two opposite connector sockets on any side of the fixture.
Make always sure so secure it with the latch. By connecting another X4 ATOM to the other side of the ATOM Connector you can build pairs/quads/lines/matrixes, etc. To release it again press the button to open the latch and slide the connector out of the socket.
GLP German Light Products 3.4 Securing the Fixture Regardless of the mounting method of the X4 ATOM you'll have to use a stipulated safety wire. Attach the safety wire through the attachment point at the back of each fixture. The safety attachment point can be deployed by simply swinging it out from the back as shown below.
Pin 1 = [Ground] / Pin 2 = [Data +] / Pin 3 = [Data -] / Pin 4 = [V+ 24V] Do not exceed 60m / 200ft. cable length for the input. Do connect the X4 ATOM to an X4 ATOM PSU only. The following models are compatible with the X4 ATOM: •...
GLP German Light Products 5 Accessories 5.1 Atom Trussbar The X4 ATOM Trussbar (GLP #767005) can hold 4 columns of X4 ATOM which can simply be connected using an ATOM Connector. Several fixtures can then easily combined to a matrix or other setups.
• Never let optical parts come into contact with oil, fat, alcohol or similar solvents. • Before running the fixture wait until all parts are dry. • Never touch lens with bare fingers. X4 Atom Head manual (v1.0) from software version: 8...
Power consumption 25 VA (Watt) Power & Signal Input 1 x 4-pin XLR: Power (24V) & Signal (RS-485) from X4 Atom PSU: Pin 1 = [Ground] Pin 2 = [Data +] Pin 3 = [Data -] Pin 4 = [V+ 24V] Max.
Need help?
Do you have a question about the X4 Atom and is the answer not in the manual?
Questions and answers