Fuses; Jump Starting Procedure - Toro 07363 Operator's Manual

Fuses

The fuses for the machine's electrical system are located
under the center of the dash panel.
1
Figure 57
1. Fuses
Figure 58

Jump Starting Procedure

Warning
Jump starting can be dangerous. To avoid personal
injury or damage to electrical components in
vehicle, observe the following warnings:
• Never jump start with a voltage sources greater
than 15 volts D.C. This will damage the
electrical system.
• Never attempt to jump start a discharged
battery that is frozen. It could rupture or
explode during jump starting.
• Observe all battery warnings while jump
starting your vehicle.
• Be sure your vehicle is not touching the jump
start vehicle.
• Connecting cables to the wrong post could result
in personal injury and/or damage to the
electrical system.
1. Loosen knobs securing battery cover to battery base and
slide cover off.
2. Connect a jumper cable between the positive posts of
the two batteries. The positive post may be identified by
a "+" sign on top of battery cover.
1. Positive (+) cable
3. Connect one end of the other jumper cable to the
negative terminal of the battery in the other vehicle. The
negative terminal has "NEG" on the battery cover. Do
not connect the other end of the the jumper cable to the
46
1
Figure 59