Onkyo DR-2000 Instruction Manual page 64

Programming the Remote Controller to Your TV
3
Press one of the programmable
buttons on the DVD Receiver's
remote controller.
The SEND/LEARN indicator goes off while
the button is pressed, then lights up again.
Lights up again shortly after going off
CH
ENTER VOL
TUN
REPEAT MUTING
A – B DIMMER
Proceed to the next step within 30
seconds.
To select another programmable button
Press one of the other programmable buttons
within 30 seconds.
4
Press and hold the desired TV's
remote control button until the
One of the TV's
SEND/LEARN indicator flashes.
remote control
If the function is successfully copied, the
buttons
SEND/LEARN indicator flashes twice.
Programming another function to the
programmed button
Carry out the steps from 1 to 4.
The previous function will be erased when the programming is
successful.
Resuming the factory setting for a
particular programmable button
After step 2, press the programmable button you wish to
resume to the factory setting twice.
• When the factory setting resumes, the SEND/LEARN
indicator flashes twice.
• If failed, the SEND/LEARN indicator flashes three times.
In this case, no change has been made to the
programmable button.
64
• Flashes twice when the programming is
successful.
• Flashes three times if the programming has
failed.
• Flashes six times if the programming is failed
because the data capacity of the
programmable button has been exceeded.
TV buttons whose data size overwhelms the
capacity of the programmable buttons are
unable to be used for programming.
Resuming the factory settings for all the
programmable buttons
1 Press and hold MODE TV, then press SEARCH twice.
The SEND/LEARN indicator flashes twice, then lights
steadily.
Proceed to the next step within 30 seconds.
2 Press MODE TV.
• When the factory settings resume, the SEND/LEARN
indicator flashes twice.
• If failed, the SEND/LEARN indicator flashes three times.
In this case, no change has been made to the
programmable buttons.
If the programmed buttons do not operate properly
• If the SEND/LEARN indicator doesn't light up when you press one of
the programmed buttons, reprogram the button.
• If the remote controller operates only at a short distance or there is
a slow response from the TV, check the batteries.
If the batteries are not weak, the pressed button is not properly
programmed. Reprogram the button.
• If the remote controller remains without batteries for 10 minutes or
more, the programmed data will be erased. In such a case, install
new batteries, then reprogram the buttons.
Using the Programmed Buttons
Press MODE TV first, then press the
programmed TV operation buttons.
CH
ENTER VOL
TUN
REPEAT MUTING
A – B DIMMER
CH
TUN
VOL
MUTING