Setting The Clock Manually - Onkyo CR-L5 Instruction Manual

CR-L5_E.book Page 18 Monday, May 19, 2003 4:05 PM
Powering Up and Setting the Clock— Continued

Setting the Clock Manually

If you cannot set the clock by using the ACCUCLOCK
function, you can set it manually. In this case, the ACCU-
CLOCK function will not automatically update the clock
each day.
You can set the clock while the CR-L5 is on or in Standby.
ON STANDBY
▼
1
Number
4
buttons
7
>10
>10
SLEEP
CLOCK CALL
DIMMER
TAPE
1
Press the [TIMER] button.
"Clock" appears on the display, as shown.
If the clock has already been set, a timer option appears
instead. In this case, you'll need to press the [TIMER]
button repeatedly until "Clock" appears.
2
Press the [ENTER] button and use the
Up/Down [ ]/[ ] buttons to select
"Manual Adj.".
3
Press the [ENTER] button.
The day of the week flashes.
18
TONE
▲ INPUT
TIMER
TIMER
2 3
▲
5 6
▼
8 9
ENTER
10/0 ENTER
VOLUME
UP
MUTING
DOWN DIRECT
DISPLAY
DISPLAY
C D PLAY MODE
CDR CLEAR
REPEAT
4
Use the Up/Down [ ]/[ ] buttons to
select a day.
5
Press the [ENTER] button.
The time flashes.
6
Use the Up/Down [ ]/[ ] buttons to
set the time.
You can use the number buttons to enter the time. For
example, to enter 19:03, press [1], [9], [10/0], and [3].
Use the [DISPLAY] button to toggle between 12- and
24-hour formats.
While the 12-hour format is selected, use the [>10] but-
ton to toggle between AM and PM.
7
Press the [ENTER] button to set the
clock.
The seconds indicator starts flashing, as shown.
Note: To cancel this procedure at any point before step 7,
press the [TIMER] button.