Part 2 Mounting The Cabinet; Remove The Front Panel Assembly; Mount The Cabinet - SentexSystems CROWN JEWEL Installation Instructions Manual

The brass Crown Jewel cabinet is easily scratched. Use care when handling.
Both the surface mount and flush-mount Crown Jewel cabinets are water-resistant, and may be
located either indoors or outdoors. Mount the cabinet as follows:
A. REMOVE THE FRONT PANEL ASSEMBLY
•
NOTES: The removal procedure for surface mount and flush mount Crown Jewel is identical.
• • • •
The optional CCTV is not shown in figure 2.
1. Using the Sentex-supplied hollow hex tool, unscrew four screws located on the front panel.
2. Carefully remove the front panel/main processor board assembly and place on a soft, clean
surface.
B. MOUNT THE CABINET
NOTE: The mounting procedure for surface mount and flush mount Crown Jewel is identical.
1. Carefully remove the knockout plug from the back or the bottom of the enclosure.
2. Mount the unit on the wall or pedestal securely. Mounting hardware is provided with Sentex's
pedestal mount. Tighten all four screws/bolts.
3. Pull all wires into the cabinet.
Page 6 of 22

PART 2 MOUNTING THE CABINET

Figure 2. Removing Crown Jewel Front Panel Assembly
Figure 3. Mounting the Crown Jewel Cabinet
Doc. 6001145
CAUTION
Rev B