Part 5 Testing And Adjusting The Unit - SentexSystems CROWN JEWEL Installation Instructions Manual

PART 5 TESTING AND ADJUSTING THE UNIT

After all connections have been made to the Crown Jewel unit, power can now be applied.
The "POWER ON" indicator on the lower left of the main processor board should now be lit.
1. Set Relay 1 Activation Time
1. On the Crown Jewel front panel keypad, enter "
password. If the password is accepted, the Crown Jewel will respond with a programming
promt consisting of two short beeps.
•
The Crown Jewel comes from the factory with the password set to "000000".
•
If you change the password during installation, make sure you write the new password down for
the customer's future reference.
•
As soon as the customer is comfortable with programming the Crown Jewel, to maintain
security it is recommended that they change the password and write it down for future
reference.
2. At the programming prompt, select programming step 23 and the desired relay activation time
by entering "23", the 1 to 3 digit activation time of between 1 and 250 seconds, and the "#" key.
For example, if you want a relay activation time of 35 seconds, at the programming prompt,
enter "2335#". If the entry is accepted, the Crown Jewel will respond with two short beeps.
3. Exit the programming mode by pressing "00#". If the command is accepted, the Crown Jewel
will respond with three short beeps.
4. On TB5 of the main processor board, place a jumper between the "EXIT1" and "COM"
terminals (see Figure 13).
5. Verify that Relay 1 activates for the correct period of time and that the gate/door opens
properly.
•
If the gate/door does not open properly, adjust the relay activation time accordingly and re-test
using steps 2 through 5, above.
2. Set Relay 2 Activation Time
If you are using Relay 2 as a control relay, program the relay activation time as follows:
1. On the Crown Jewel front panel keypad, enter "
password. If the password is accepted, the Crown Jewel will respond with a programming
promt consisting of two short beeps.
Rev B
Figure 13. Relay Test Jumpers on Main Processor Board TB5.
Doc. 6001145
∗∗∗ ∗∗∗ ∗∗∗ ∗∗∗
" and then the six digit programming access
∗∗∗ ∗∗∗ ∗∗∗ ∗∗∗
" and then the six digit programming access
Page 15 of 25