Appendix 1 Installation Programming Menu - SentexSystems CROWN JEWEL Installation Instructions Manual

•
Each programming command begins with a 2-digit step number, followed by the required data digits, and
ended by the "#" key.
•
The step number tells the Crown Jewel which setting to change, and the digits contain the new value for
that setting.
•
If the step and data are valid, the unit responds with 2 short beeps.
If you do not hear 2 short beeps, the unit did not understand the input.
•
If an error is made during an entry, press the "∗" key to cancel the command.
STEP
00 Exiting Programming Mode
01 Changing the Unit Password
02 Verifying the Unit Password
03 Creating an Entry Code
04 Erasing an Entry Code
21 Enabling/Disabling Alarm Call
22 Setting the Alarm Call Number
23 Setting Main Gate time
24 Setting Auxiliary Relay Time
26 Setting Auxiliary Relay and Status
Configuration
27 Setting the Date and Time
29 Setting the Rings Before Answer
30 Adjusting the Sidetone Balance
31 Restoring Factory Defaults
32 Resetting the Unit
33 Enabling/disabling the No-Telco Mode
35 Enabling Direct Commands
37 Beep Unit Number
38 Setting the Unit Number
43 Overriding Telephone Company Answering
Service
90 Initiate audio communication through Crown
Jewel
91 Cycling the Main Gate
92 Cycling the Auxiliary Relay
93 Latching the Main Gate
94 Latching the Auxiliary Relay
95 Releasing the Main Gate
96 Releasing the Auxiliary Relay
97 Releasing Both Relays
98 Latching the Main Gate Until XXXX
99 Latching the Auxiliary Relay Until XXXX
Page 20 of 22
INSTALLATION PROGRAMMING MENU
PURPOSE
APPENDIX 1
DIGITS
6
6
4, 5, or 6
4
1
up to 11
up to 3
up to 3
1
11
up to 2
1
1
2
2
4
4
Doc. 6001145
ACCEPTABLE INPUT
4-digit entry code + relay code+time
zone
4-digit entry code
0=disable, 1=gate breach only,
2=keypad strikeout, 3=both
00=disables the number
1 through 250 seconds
1 through 250 seconds
0=Control (with exit request),
1=Shunt,
2=Alarm,
3=CCTV (manual),
4=CCTV (instant),
5=Control (with position sense)
year + month + day + day of the week +
hour + minute
1 through 15 rings
generate 45 second tone
0=disable, 1=enable
0=disable, 1=local, 2=remote, 3=both
this unit number + total number of units
43 + delay time in seconds + #
ending time
ending time
Rev B