Remote Keypad; Auto-Call Sensor - SentexSystems CROWN JEWEL Installation Instructions Manual

C. REMOTE KEYPAD
The Crown Jewel accepts a second, remote keypad for added versatility. Install the remote
keypad as follows:
♦ The remote keypad installation requires a shielded 7 conductor, 18 to 24 AWG cable such as
Belden Datalene #9932 or equivalent.
1. Connect one end of the cable to TB4 on the Crown Jewel's main processor board (see
Figure 11).
2. Connect the opposite end of the cable to area TB1 on the Remote Keypad board.
3. Connect the cable shield to the ground screw on the lower left corner of the main processor
board (see Figure 11).
D. AUTO-CALL SENSOR
The Crown Jewel has a special feature called "Auto-Call" which automatically places a visitor
call to the residence when a driveway sensor (or any device that provides a contact closure) is
activated. Connect a driveway sensor or other device to the Crown Jewel as follows:
♦ The Auto-Call installation requires a 2 conductor shielded cable (such as Belden 8771).
1. Connect one end of the cable to the driveway sensor.
2. Connect the other end of the cable to the "AUTOCALL" and "COM" pins on TB5 of the main
processor board (see Figure 12).
3. Connect the cable shield to the ground screw on the lower left corner of the main processor
board (see Figure 12).
Page 14 of 22
Figure 11. Remote Keypad Wiring.
Figure 12. Auto-Call Wiring.
Doc. 6001145 Rev B