Basic Operation
STANDBY indicator
STANDBY/ON
PHONES
Turning On the CD Receiver
CD receiver
To turn on the CD receiver, press the [STANDBY/ON]
button on the CD receiver or remote controller. The
STANDBY indicator goes off.
Press the [STANDBY/ON] button again to set the CD
receiver to Standby. The STANDBY indicator lights up.
Tip:
When you start playback on (or turn on) an Onkyo RI
Dock, CD recorder, MD recorder, or cassette deck that's
connected to the CD receiver with an
log audio cable, the CD receiver turns on automatically.
Similarly, when you set the CD receiver to On or
Standby, the other component will also be set to On or
Standby.
Adjusting the Volume
CD receiver
Turn the [VOLUME] control clockwise to increase the
volume or counterclockwise to decrease it.
You can also use remote controller's VOLUME
[
]/[
] buttons.
VOLUME
INPUT
Remote
controller
cable and ana-
Remote
controller
STANDBY/
ON
Selecting the Input Source
You can select CD, DAB, AM, FM, or a connected com-
ponent (TAPE, DOCK, LINE, DIGITAL) as the input
source.
To select the input source, press the remote controller's
INPUT [
]/[
] buttons repeatedly. On the CD
receiver, press the [INPUT] button repeatedly. The input
sources are selected in the following order.
• CR-515DAB
1,
2
*
*
DIGITAL
CD
LINE2
LINE1
• CR-315DAB
CD
DAB
FM
LINE
*1 Input Display can be changed (see page 29).
*2 CR-515DAB only.
Using Headphones
Turn down the volume, then connect your stereo head-
phones to the PHONES minijack.
You can adjust the volume and mute the sound, as
explained earlier.
The speakers output no sound while the headphones are
connected.
PHONES jack
INPUT
/
VOLUME
/
DAB
FM
AM
1
1
*
*
DOCK
TAPE
1
*
TAPE
AM
DOCK
27