Fuel System Maintenance; Draining The Fuel Tank - Toro 30632 Operator's Manual

Commercial walk-behind mower
Hide thumbs Also See for 30632:
Table of Contents

Advertisement

4. Clean around the spark plugs to prevent dirt from
falling into the engine and potentially causing
damage.
5. Remove the spark plugs and the metal washers.
Checking the Spark Plugs
1. Look at the center of the spark plugs (Figure 29).
If you see light brown or gray on the insulator, the
engine is operating properly. A black coating on the
insulator usually means that the air cleaner is dirty.
2. If needed, clean the spark plug with a wire brush to
remove carbon deposits.
Figure 29
1. Center electrode insulator
2. Side electrode
Important: Always replace the spark plugs
when it has worn electrodes, an oily film on it,
or has cracks in the porcelain.
3. Check the gap between the center and side electrodes
(Figure 29). Bend the side electrode (Figure 29) if
the gap is not correct.
Installing the Spark Plugs
1. Install the spark plugs and the metal washer. Ensure
that the air gap is set correctly.
2. Tighten the spark plugs to 16 ft-lb (22 N-m).
3. Connect the wires to the spark plugs (Figure 29).
3. Air gap (not to scale)
Fuel System
Maintenance

Draining the Fuel Tank

DANGER
In certain conditions, gasoline is extremely
flammable and highly explosive. A fire or explosion
from gasoline can burn you and others and can
damage property.
• Drain gasoline from the fuel tank when the
engine is cold. Do this outdoors in an open area.
Wipe up any gasoline that spills.
• Never smoke when draining gasoline, and stay
away from an open flame or where a spark may
ignite the gasoline fumes.
1. Park the machine on a level surface, to assure fuel
tank drains completely. Then disengage the power
take off (PTO), set the parking brake, and turn the
ignition key to off. Remove the key.
2. Close the fuel shut-off valve at the fuel tank
(Figure 30).
3. Squeeze the ends of the hose clamp together
and slide it up the fuel line away from fuel filter
(Figure 30).
4. Pull the fuel line off the fuel filter (Figure 30). Open
the fuel shut-off valve and allow the gasoline to drain
into a gas can or drain pan.
Note: Now is the best time to install a new fuel filter
because the fuel tank is empty. Refer to Replacing
the Fuel Filter.
5. Install the fuel line onto the fuel filter. Slide the hose
clamp close to the valve to secure the fuel line.
27

Advertisement

Table of Contents
loading

This manual is also suitable for:

3063430638396343963839632

Table of Contents