Operating The Blade Control (Pto) Lever; The Safety Interlock System - Toro 30632 Operator's Manual

1. Throttle control
2. Ignition switch
Operating the Blade Control
(PTO) Lever
The blade control (PTO) lever engages and disengages
the power to the mower blades.
Engaging the Mower Blades (PTO)
1. Squeeze the operator presence control (OPC) levers
against the handles (Figure 9).
2. Push the blade control (PTO) lever firmly forward
until it latches over the center (Figure 9).
3. Restart the engine and repeat the procedure to
engage the mower blades if the operator presence
control (OPC) levers are released.
Disengaging the Mower Blades (PTO)
To disengage the blades, pull the blade control lever
rearward all the way (Figure 9). The engine will kill
when the OPC levers are released with the blade control
lever engaged.
Figure 8
3. Choke
1. Operator Presence
Control (OPC) lever

The Safety Interlock System

CAUTION
If safety interlock switches are disconnected or
damaged the machine could operate unexpectedly
causing personal injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock switches
daily and replace any damaged switches before
operating the machine.
Understanding the Safety Interlock
System
The safety interlock system is designed to prevent the
engine from starting unless:
• The blade control (PTO) lever is disengaged.
• The machine is shifted into the Neutral position.
• The ignition key is in the Run position.
The safety interlock system is designed to stop the
engine when:
• The Operator Presence Control (OPC) levers are
released when the transmission or the blades are
engaged;
• The ignition key is turned to the Off position.
• The machine is shifted into gear without holding
the OPC levers.
• The blade control (PTO) lever is engaged without
holding the OPC levers.
15
Figure 9
2. Power take off lever (PTO)