Toro 30632 Operator's Manual page 35

6. If there is no adjustment left in the turnbuckle and
the belt is still loose, the rear idler pulley needs to be
positioned to the middle or front hole (Figure 44).
Use the hole that will give the correct adjustment.
7. When the idler pulley is moved the belt guide must
be moved. Move the belt guide to the front position
(Figure 44).
1. Rear idler pulley
2. Middle hole
3. Front hole
8. Check the belt guide under the engine frame for
proper adjustment (Figure 45).
Note: The distance between the belt guide and
the mower belt should be 3/4 inch (19 mm) when
you engage the mower belt (Figure 45). Adjust the
mower belt as necessary. The disengaged belt should
not drag or fall off the pulley when the guides and
belt tension are properly adjusted.
9. Check the blade brake adjustment; refer to Adjusting
the Blade Brake.
Figure 44
4. Belt guide in back position
5. Front idler pulley
1. Idler pulley in slot
2. Traction belt
3. Mower belt
Adjusting the PTO Engagement
Linkage
The PTO engagement linkage adjustment is located
beneath the front left hand corner of the engine deck.
1. Disengage the blade control (PTO) lever and set the
parking brakes.
2. Stop the engine and wait for all moving parts to stop
before leaving the operating position.
3. Engage the blade control lever (PTO).
4. Adjust the linkage length to where the lower end
of the bellcrank just clears the axle support gusset
(Figure 46).
35
Figure 45
4. Belt guide
5. 3/4 inch (19 mm)
6. Mower belt