Operating Instructions - Ipi; Ecologic Control - Vermont Castings VFF32LI Installation & Operating Instructions Manual

OPERATING INSTRUCTIONS – IPI
20308184
OPERATIONS AND INDICATIONS
CONTROL
BOARD
System Set Up Chart
NOTE: When using ON/OFF wall switch, the master switch, located in bottom of fi replace must be in the
ON position to perform all confi guration setup operations.
FUNCTION OPERATION
Cold Climate Pilot On/Off Flip the toggle switch to ON.
Operations
FUNCTION OPERATION
Power Up Flip the Master Switch to ON position to power up the system.
Turn on wall switch to turn the fi replace on. NOTE: If master switch was
Fireplace On just switched to ON, then at fi rst use of wall switch, it may need to be
turned ON - OFF - ON to synchronize the two switch settings.
Turn the wall switch to the OFF position, or turn the ON/OFF master
Fireplace Off
switch to the OFF position
Self Diagnostics Chart
The fi replace has a self diagnostic LED on the control board enabling you to troubleshoot problems and
potentially avoid a service call. Please refer to the chart below for indicator reference.
FUNCTION OPERATION
Sparking error Red LED, Flash 2 times
Flame error Red LED, Flash 3 times
Ignition fail Red LED, Flash 4 times
Re-ignite warning Red LED, Flash 5 times
Pilot valve voltage error Red LED, Flash 6 times
Main valve voltage error Red LED, Flash 7 times
Low battery Red LED 2.5 sec, Flash once
Remote Operations
The following functions are available on the RMSC hand held remote.
NOTE: Flame height control is only available with purchase and installation of a stepper motor kit with RF
receiver
REMOTE FUNCTION OPERATION
Fireplace On Press the ON button on the transmitter.
Press the OFF button 3 times or hold the OFF button 3
Fireplace Off
seconds for memory off.
Press the ON button once to turn on the fi replace with
Flame Height Up
maximum fl ame setting.
Press the OFF button to lower the fl ame height to
Flame Height Down
medium and low.
Press TIMER button to enter the timer mode. Keep
Count Down Timer Mode pressing the TIMER button to set the desired time or
press TIMER button to "0" to exit timer mode.
®
2 2 .0
Cold
Climate
Switch
Master
Switch
DEFAULT
SETTING
OFF
ICON
VFF Vent Free Fireplace System
21