Table of Contents
Advertisement
1
2
3
4
Figure 50
1. F1; main-30 amp
2. F2; regulator-25 amp
Replacing Headlights
Specification: Bulb # 1156 Automotive Type
Removing the Bulb
1. Disengage the PTO, set the parking brake, lower the
attachment lift, stop the engine, and remove the
ignition key.
2. Open the hood.
3. Pull the wire connectors off both bulb holder
terminals.
4. Rotate the bulb holder 1/4 turn counterclockwise and
remove it from the reflector (Fig. 51).
5
3
2
4
Figure 51
1. Bulb holder
2. Reflector
3. Tabs
m–3316
3. F3; dash, interlock-10 amp
4. F4; headlights-10 amp
5
1
4
4. Slots
5. Terminals
30
5. Push and rotate the bulb counterclockwise until it stops
(approx. 1/4 turn) and remove the bulb from the bulb
holder (Fig. 52).
2
4
3
Figure 52
1. Bulb
2. Metal pins
Installing the Bulb
1. The bulb has metal pins on the side of its base. Align
the pins with the slots in the bulb holder and insert the
base into the holder (Fig. 52). Push and rotate the bulb
clockwise until it stops.
2. Align the two tabs on the bulb holder with the slots in
the reflector and insert the bulb holder into the
reflector (Fig. 51).
3. Rotate it 1/4 turn clockwise until it stops.
4. Push the wire connectors onto the terminals on the
bulb holder.
5. Close the hood.
Replacing Taillights
Specification: Bulb GE 194
Removing the Bulb
1. Disengage the PTO, set the parking brake, lower the
attachment lift, stop the engine, and remove the
ignition key.
2. Remove the two screws securing the lens (Fig. 53).
1
2
4
3. Bulb holder
4. Slots
Advertisement
Table of Contents
