Changing The Transaxle Fluid - Toro 07277 Operator's Manual

Figure 47
6. Install the clutch cover and secure it with the 3 bolts
removed previously.

Changing the Transaxle Fluid

Change the transaxle fluid every 800 operating hours or
yearly, whichever occurs first.
1. Position the vehicle on a level surface, set the parking
brake, turn the ignition off, and remove the key.
2. Remove the drain plug from the right side of the
reservoir (Figure 48) and let the fluid flow into a
drain pan. Install and tighten the plug when the fluid
stops draining.
Note: Dispose of the used oil at a certified recycling
center.
Figure 48
1. Drain plug
3. Fill the reservoir (Figure 49) with approximately
1-1/2 qt. (1.4 liters) of SAE 10W30 motor oil
or until the oil level is at the bottom of the level
indicator hole (Figure 48).
2. Level indicator hole
1. Oil fill
4. Start the engine and operate it to fill the system.
Recheck the oil level and replenish it, if required.
37
Figure 49