Cleaning; Washing The Vehicle - Toro 07277 Operator's Manual

Figure 53
1. Generator pivot bolt
3. Wedge a pry bar between the engine mount and
starter. Loosen the nut on the adjusting carriage bolt
(Figure 53).
4. Tilt the starter in the slot until the belt flexes 1/4 inch
(6 mm) with 10 lb (44.5 N) of force.
5. Tighten the carriage bolt nut and remove the pry bar.
Tighten the starter generator pivot bolt (Figure 53).
2. Adjusting carriage bolt

Cleaning

Washing the Vehicle

The vehicle should be washed as needed. Use water
alone or with a mild detergent. A rag may be used,
however the hood will loose some of its luster.
Important: Pressurized water is not recommended
when washing the machine. It may damage the
electrical system, loosen important decals, or wash
away necessary grease at friction points. Avoid
excessive use of water, especially near the control
panel, engine, and battery.
40