Caution · Please Read; Safety Instructions For Hand-Operated Petrol Power Scythe; Preliminary Measures; Handling - AL-KO FRS 410 Manual

1 CAUTION · PLEASE READ
For safety reasons, it is imperative that you read these
operating instructions before using the appliance. Seri-
ous injuries could result if these instructions are not
followed. You must therefore dedicate a few minutes to
studying your new power tool and its instructions be-
fore each use.
1.1 Safety instructions for hand-operated
petrol power scythe
Read the directions with due care. Familiarize yourself
with the settings and proper operation of the machine.
Never allow children or other persons who are not
familiar with the operating instructions to use the petrol
power scythe. Contact your local governmental agency
for information regarding minimum age requirements
for operating the petrol power scythe.
Never mow in the direct vicinity of persons -especially
children - or animals.
Maintain a safety distance of 15m. If ap-
proached, switch off the appliance immedi-
ately. Always keep in mind that the machine
operator or user is responsible for accidents
involving other persons and/or their property.
1.2

Preliminary measures

−
Always wear sturdy, non-slip footwear and long
trousers when mowing. Never mow barefoot or in
sandals.
−
Check the grounds on which the machine will be
used and remove all objects that could be caught
up and violently flung out.
Warning: Petrol is highly flammable!
−
Only store petrol in containers designed to hold
petroleum-based liquids
−
Only refuel out in the open and do not smoke
during the refueling process.
−
Always refuel before starting the engine. Do not
open fuel tank cap and do not refuel when the en-
gine is running or when the scythe is hot.
−
If petrol has overflowed, do not under any circum-
stances attempt to start the engine. Instead, re-
move the machine from the affected area. Avoid
starting the engine until the petrol fumes have
completely evaporated.
−
For safety reasons, the petrol tank and other tank
closures must be replaced if they are damaged.
−
Replace defective mufflers.
−
Before using the scythe, visually inspect it to en-
sure that the blade, mounting bolts and the entire
cutting apparatus are in good working order (i.e.
not worn out or damaged). To prevent any imbal-
ance, replace worn out or damaged blades and
mounting bolts as a set only (if applicable).
1.3

Handling

1. Wear close fitting, tough work clothing that will
provide protection, such as long slacks or trou-
sers, safety work shoes, heavy duty work gloves,
hard hat, a safety face shield, or safety glasses
for eye protection and a good grade of ear plugs
or other sound barriers for hearing protection.
2. Store in a safe place. Open fuel cap slowly to
release any pressure which may have formed in
fuel tank. To prevent a fire hazard, move at least
10 feet (3 meters) from fueling area before start-
ing.
3. Turn unit off before setting it down.
4. Always hold unit firmly with both hands, the
thumb and fingers encircling the handles.
5. Keep all screws and fasteners tight. Never
operate your equipment when it is improperly ad-
justed or not completely and securely assembled.
6. Keep handles dry, clean and free of fuel mixture.
7. Keep stringhead as close to ground as practi-
cal. Avoid hitting small objects with stringhead.
When cutting on a slope, stand below stringhead.
NEVER cut or trim on a hill or slope, etc. if there
is the slightest chance of slipping, sliding or losing
firm footing.
8. Check area you will be trimming for debris that
may be struck or thrown during operation.
9. Keep all parts of your body and clothing away
from stringhead when starting or running engine.
Before starting engine, make sure stringhead will
not come in contact with any obstacle.
10. Stop engine before examining cutting line.
11. Store equipment away from possible flamma-
ble materials, such as gas-powered water heat-
ers, clothes dryers, or oil-fired furnaces, portable
heaters, etc.
12. Always keep the debris shield, stringhead, and
engine free of debris build-up.
13. Operation of equipment should always be re-
stricted to mature and properly instructed indi-
viduals
GB 2