Learning Feature - One for All URC-7560 User Manual & Code Book

Advanced Features
Learning
The ONE FOR ALL 6 comes with a complete library of
preprogrammed codes. After you have set up the ONE FOR
ALL 6 for your device, you may find that there are one or
more keys which you had on your original remote which do
not have a place on the ONE FOR ALL keypad.
As a convenience, the ONE FOR ALL 6 offers a special Learning
feature that allows you to copy any function from your original
remote control onto the keypad of the ONE FOR ALL 6.
To use the Learning feature, please follow the instructions
below. Please note, the "custom keys" A-H have been
especially provided for this feature. By using these keys, you
will not have to sacrifice an existing function on the ONE FOR
ALL 6 keypad. (If you require to learn more than four features
per mode, you will need to place the learned function on
another key. Please see the next section titled Shifted
Learning.)
Before you start:
- Make sure your original remote control is working correctly.
- Make sure neither your ONE FOR ALL nor your original
remote controls are pointing at your device.
1 Place both remote controls (the ONE FOR ALL 6
and your original) on a flat surface. Make sure
the ends which you normally point at your device
are facing each other. Keep the remotes at a
distance of 2 to 5 cm.
2 Press and hold the MAGIC key until the device key
blinks twice (the device key blinks once then twice).
3 Press 975 (the device key will blink twice).
4 Press the device key (on the ONE FOR ALL remote)
to select the mode to which you want to copy the
learned function.
5 Press the key (on the ONE FOR ALL remote) where
you want to place the learned function (the device key
will flash rapidly).
6 Press and hold the key (on your original remote)
that you want to copy until the device key on the ONE
FOR ALL blinks twice.
7
If you want to copy other functions within the same
mode, simply repeat steps 5 and 6 pressing the next key
you want to copy by learning. If you would like to
continue learning but in a different mode (with
another original remote), repeat steps 4-6.
8 To exit the learning mode, press and hold MAGIC
until the device key blinks twice.
9 Learning is mode specific. To access your learned
function, press the appropriate device key first.
30
WWW.ONEFORALL.COM