The Search Method - One for All URC-7560 User Manual & Code Book

Installation

The Search Method

If your device does not respond to the ONE FOR ALL 6 after
you have tried all the codes listed for your brand, try
searching for your code. The Search Method allows you to
find the code of your device by scanning through all the codes
contained in the memory of the ONE FOR ALL 6. The Search
Method may also work if your brand is not listed at all.
If you cannot get your ONE FOR ALL 6 to control your television.
To search for your TV code:
1 Switch your television on (not in standby) and aim your
ONE FOR ALL at your TV.
2 Press the TV key on your ONE FOR ALL 6.
3 Press and hold down MAGIC until the
ONE FOR ALL 6's TV key blinks twice (The
TV key will blink once and then twice).
4
Press 9 9 1. The TV key will blink twice
(The TV key will blink once and then
twice).
5
Now slowly, alternate between TV and
POWER, over and over, until your
television turns off. You may have to
press these keys many times, so please be
patient. Remember to keep pointing the
ONE FOR ALL 6 at your television when
you press the TV and POWER keys.
As soon as your television turns off,
6
press MAGIC.
7 The ONE FOR ALL remote should now be
ready to operate your device. Turn your
device back on and try all the remote's
functions to ensure they are working
properly. If some of the ONE FOR ALL's
commands are not operating correctly,
try the search method again. You may be
using the wrong code.
Important notes:
- To search for the code for another device follow the instructions
above only press the appropriate device key (see chart on page
8) instead of TV during steps 2 and 5.
- If the original remote control of your device does not have a
power key, press PLAY instead of POWER during step 5.
- During step 5, you may have to press these keys many times (up
to 150!) so be patient. Remember you must aim the ONE FOR ALL
at your device the entire time you are searching for your code.
WWW.ONEFORALL.COM
9