Stability Data - Toro 22323 Operator's Manual

Stability Data

The following tables list the maximum slope recommended for the traction unit in the positions listed in the tables.
Slopes over the listed degree may cause the traction unit to become unstable. The data in the tables assume that the
loader arms are fully lowered; raised arms may affect the stability.
In each attachment manual is a set of three stability ratings, one for each hill position. To determine the maximum
slope you can traverse with the attachment installed, find the degree of slope that corresponds to the stability ratings
of the attachment. Example: If the attachment installed on a TX model 22323 traction unit has a Front Uphill rating
of B, a Rear Uphill rating of D, and a Side Uphill rating of C, then you could drive forward up a 19° slope, rearward
up a 12° slope, or sideways on a 14° slope, as listed in the following table.
Model 22323
Configuration
Traction unit without attachment
Traction unit with an attachment rated with one of the following stability ratings
for each slope position:*
A
B
C
D
E
Model 22324
Configuration
Traction unit without attachment
Traction unit with an attachment rated with one of the following stability ratings
for each slope position:*
A
B
C
D
E
Maximum Recommended Slope when
Front Uphill
11°
25°
19°
16°
10°
5°
Maximum Recommended Slope when
Front Uphill
12°
25°
22°
18°
10°
5°
16
Operating with:
Rear Uphill Side Uphill
21° 19°
25° 20°
19° 18°
15° 14°
12° 9°
5° 5°
Operating with:
Rear Uphill Side Uphill
19° 21°
25° 23°
22° 20°
16° 14°
10° 10°
5° 5°