Replacing The Fuses; Replacing The Headlights - Toro 07299 Operator's Manual

10. Connect the long, red, main positive lead between
the bank of batteries and the vehicle (Figure 29).
11. Connect the long, black, main negative lead between
the bank of batteries and the vehicle (Figure 29).
12. Torque the nuts securing all battery cables to 120 to
180 inch-lb (13.5 to 21 N-m).
13. Coat the battery terminals with Toro battery terminal
protector.
14. Ensure that the rubber boots on each battery cable
are securely seated over the battery terminals.
Storing the Batteries
Charge the batteries fully before placing the vehicle into
storage. Plug the charger into a wall outlet while the
vehicle and batteries are in storage. Leave the charger
plugged into a wall outlet and charging receptacle during
storage to ensure that the batteries stay charged and do
not freeze; otherwise, charge the batteries at least once
every 3 months.

Replacing the Fuses

There are 2 fuses in the electrical system. They are
located beneath the dash on the driver's side (Figure 30).
Power Point
Open
Lights and Horn
2
G008769
1. Vehicle fuse holder

Replacing the Headlights

Before performing any maintenance set the parking
brake, turn the On/Off switch to Off, and remove the
key.
10 A (15 A max.)
1
Figure 30
2. Relay
Release the retaining straps on the hood and raise the
hood to access the headlights.
Replacing the Bulbs
CAUTION
The halogen bulbs become extremely hot when in
operation. Handling a hot bulb can cause severe
burns and personal injury.
Always all enough time to for the bulbs to cool
before replacing them. Use care whenever handling
the bulb.
CAUTION
Any surface contamination can damage the
headlight bulb and leading to its failure or explosion
creating a serious safety hazard.
Head light lamps should be handled without
touching the clear quartz, either by using a clean
paper towel or carefully holding the base.
Specification: See your Parts Catalog.
1. Disconnect the electrical harness from the bulb
housing on the back of the lamp.
2. Remove the protective rubber boot (Figure 31).
10 A
10 A
1. Headlight
2. Speed clip and flat washer 5. Rubber boot
3. Headlight bulb
3. Release the plastic retaining ring by turning it 1/4
turn counter clockwise. Remove the ring.
4. Remove the bulb assembly by moving it rearward,
out of the lamp housing.
5. Install a new bulb into the lamp housing. Use a
paper towel to grasp the new bulb with handling it
to avoid contaminating the surface.
6. Secure the bulb in place by installing the retaining
ring. Turn the ring 1/4 turn clockwise to lock it in
place.
29
Figure 31
4. Retaining ring
6. Headlight bulb harness
connection