Checking The Tire Pressure - Toro 74253 Setup Instructions

Step
1
Removing Parts from the
Crate
No Parts Required
Procedure
Remove the tires and the parts for the ROPS from
the shipping crate.
Step
2

Checking the Tire Pressure

No Parts Required
Procedure
Pressure: 13 psi (90 kPa)
Note: The front caster wheel is a semi-pneumatic
tire and does not need to be checked.
Check the air pressure in the drive tires.
Figure 1
Step
3
Raising the Machine Up and
Installing the Drive Wheels
Parts needed for this step:
2 Rear wheels
Procedure
1. Remove the screws holding the right angle
retaining plate to the crate.
Figure 2
2. Raise the back of the machine up and support
it with jack-stands.
Figure 3
3. Remove the wheel nuts from both sides of the
vehicle and remove the right angle retaining
plate. Discard the screws and retaining plate.
2