Maintenance; Recommended Maintenance Schedule - Toro 30581 Groundsmaster 580-D Operator's Manual

If it is an emergency and it becomes necessary to stop
suddenly while in cruise control, depress the service brake
pedal, this breaks the electrical circuit, returns the traction
pedal to neutral and stops the machine.
Stopping the Machine
To stop the machine and cease operation, take foot off
traction pedal and apply the brakes. Move the throttle lever
to SLOW, ground speed selector to LOW RANGE and

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule

Maintenance Service
Interval
After first 10 hours
After first 50 hours
Every 50 hours
Every 100 hours
Every 200 hours
Every 400 hours
Maintenance Procedure
Check the fan and alternator belt adjustment.
Torque the wheel lug nuts.
Check the cutting unit drive belt adjustment.
Change the engine oil and replace the filter.
Replace the hydraulic filter.
Torque head and adjust valves.
Check the engine RPM (at idle and full throttle).
Change the planetary gear drive fluid.
Lubricate all grease fittings.
Inspect the air filter, dust cup, and baffle.
Clean under the cutting unit belt covers.
Check the cutting unit drive belt adjustment.
Change the engine oil and replace the filter.
Check the fan and alternator belt tension.
Inspect the cooling system hoses.
Service the air filter.
Replace the fuel/water separator filter.
Torque the wheel lug nuts.
Check the battery level and cable connections.
Replace the hydraulic filter.
Torque head and adjust valves.
Check the engine RPM (at idle and full throttle).
32
deck lift controls to neutral. Switch cruise control to OFF,
set the parking brake and turn ignition key to OFF. Remove
the key if the machine is to be left unattended.