Toro 30581 Groundsmaster 580-D Operator's Manual page 10

99-1900
1. Read the operator's
manual for maintenance
procedures.
2. Traction reverse test port
95-0845
1. Height-of-cut settings
95-0820
1. Belt routing for right-hand cutting unit
3. Traction forward test port
4. Charge pump test port
5. Steering circuit test port
6. Deck lift test port
10
98-3040
1. Engine stop
2. Engine run
3. Engine start
4. Preheat
5. Engage deck drive
6. Disengage deck drive
7. High range ground speed
8. Low range ground speed
9. Push the button to
engage the cruise control.
10. Cruise control on
11. Cruise control off
12. Headlights on
13. Headlights off
14. Push the button to
over-ride an overheated
engine shutdown.
15. To start the engine, keep
your foot off of the traction
pedal, set the parking
brake, put the throttle
lever in Slow, and turn the
ignition switch.
16. To stop the engine,
disengage the deck drive,
put the throttle lever in
Slow, set the parking
brake, turn the ignition
key to Off, and remove
the key from the ignition.
17. To engage deck drive, pull
sleeve upward on switch
lever, push lever to
ENGAGE position and
release to actuate switch.
18. Fully raise cutting units
before operating in HIGH
RANGE ground speed.