Programming Favorite Channel Scan; Changing Volume Lock; Locking Volume Control To One Mode; (Global Volume Lock) - One for All URC-3300 User Manual

PROGRAMMING FAVORITE CHANNEL SCAN

In the or
CBL/SAT
in any order, that will be immediately scanned when
Using Channel Scan
NOTE: Favorite channels can only be programmed for one mode. After programming, if FAV
is pressed while in another mode, the remote control will start scanning all channels instead
(if applicable to the selected device).
1.
2.
3.
4.
5.
6.

CHANGING VOLUME LOCK

The One For All 3 Device Universal Remote Control is set at the factory for
independent volume control of each selected device. However, you may
change the Volume Lock setting to
ume will be locked to one mode (e.g., to control TV volume in all other
modes).After that, if desired, you can perform
a selected device to set its volume control for independent operation.

Locking Volume Control To One Mode

(Global Volume Lock)

1.
mode, you can store a list of up to 10 favorite channels,
TV
on the previous page).
On the remote control, press
Press and hold
then release
SET
Enter - - . The
9 9 6
Use the keypad to enter a favorite channel number (e.g.,
). Then press
031
NOTE: If the original remote control required pressing an Enter key
to change the channel, also press the ENTER key after the channel
number (e.g., 0 - 3 - 1 - ENTER). On some satellite receivers and cable
boxes, you may need to press the SELECT (OK) key instead of ENTER.
If desired, repeat step 4 for each channel to be stored, up
to a total of 10 channels.
NOTE: If you try entering more than 10 channels, the remote control
will automatically exit programming. To change your favorite chan-
nel list at this point, you will first need to delete the existing list by
performing the steps in "Clearing Custom Programming" on page 14.
Then, perform the instructions in this section once again.
To exit programming with less than 10 favorite channels
stored, press and hold
Otherwise, the remote control will automatically exit the
program after 10 channels have been stored.
Press and hold
then release
SET
CBL/SAT
until the
SET LED
.
will blink twice.
LED
once.
SET
until the
SET
Global Volume Lock
Individual Volume Unlock
until the
SET LED
.
12
is pressed (see
FAV
or once.
TV
(red light) blinks twice,
blinks twice.
LED
so that a device's vol-
(red light) blinks twice,
continued on next page...
on