Table of Contents
Advertisement
OFA Kameleon wRF UG rev 3.fm Page 30 Monday, September 13, 2004 11:18 AM
K
AMELEON
A macro can be used to control a home theater operation, to set a favorite
channel, or for other multiple functions you would like to control with one
key press. Moreover, each Macro Key can hold up to 15 key presses total.
NOTE: Programming a new macro over an existing one erases the original.
P
F
ROGRAMMING A
AVORITE
With so many channels available on your cable or satellite system, you can
program a macro that directly selects a favorite channel with one key press.
For example, let's assume your favorite cable programs are on channel 71.
Use the following instructions to program a macro for direct access of this
channel:
NOTE: . The following example assumes all equipment is turned off and that the
TV is connected through the Cable Box with TV tuning set to channel 3.
1.
Press and hold SETUP until the two bottom IR
segments flash twice. The Program Keys
appear as SETUP flashes repeatedly.
2.
Press MACRO once.The Macro programming screen appears:
NOTE: If there are more than 15 key presses in the sequence, the bottom
IR segments display a long flash denoting an error. The display returns to
the last-selected device menu screen. To program the macro, start again
with step 3.
30
8-D
R
EVICE
EMOTE WITH
C
M
HANNEL
ACRO
3.
Press an open Macro Key
(e.g.,M1,M2,M3, or M4). The last-
selected device menu screen, including
HOME, appears.
4.
Enter a macro sequence of up to 15 key
presses. For this example, press TV
once, followed by POWER once, and
then enter 0 3 for the TV's channel
number. Next, press CBL/SAT once,
followed by POWER once, and then enter
0 7 1 for the Cable Box's channel
number.
RF
Using Macros
Advertisement
Table of Contents
