Mitsubishi PLK-E03BT Technical Manual page 24

(6) Set sewing speed by pressing
below.
Changeover to normal mode
function
The setting value displayed in LED 5 is
validated, and the normal mode is
returned to.
Setting value changeover function
(decrement)
With each press, the LED 5 display (setting
value) will decrement by one.(0,9 ... 2,1,0,9)
Setting value changeover function
(increment)
With each press, the LED 5 display (setting
value) will increment by one.(0,1 ... 8,9,0,1)
(7) Insert the sewing material under the work holder (NO.3) then, step on the foot switch
(NO.2) lightly. The work holder comes down to press the sewing material.
(8) When the foot switch (NO.2) is depressed further deeper from the lightly depressed
position, stitching is initiated begging with home position.
NOTE The sewing material will be released after the foot switch (NO.2) becomes free again
before starting the machine.
(9) After finished the sewing, the work holder (NO.3) is lifted automatically then, the sewing
material is released.
Cution
★In case of (5)., if the foot switch (NO.2) strongly and rapidly, the machine will start sewing
immediately after work holder goes down.
A key on the setting panel. Then LCD shows like
LED1
H
F
－19－
LED2 LED3 LED4 LED5
A
B C D
Key operation invalid
Nothing will occur even if the
key is operated.
Setting value changeover function
(increment)
With each press, the LED 5 display (setting
value) will increment by one.(0,1, ... 8,9,0,1)