Table of Contents
Advertisement
5. PROPER OPERATION
5-1 Loading the system software to the control box
When the brand new machine is operated first time or when the control box is adjusted for the
repairing, the system software has to be loaded to the control box.
For this loading, please take the following procedure.
O F F
O N
1
2
5-1 Installation of the needle
Caution
Please make sure to turn the power switch OFF before installing or replacing the needle.
Please pay attention for the fingers not to be wounded by the needlepoint.
4
(1)
(2)
3
(3)
(4)
(1) Loosen the needle set screw (NO.1) then,
insert the new needle (NO.2) until the needle
3
head is reached the end of the hole of the
needle bar (NO.3).
(2) Fasten the setting screw (NO.1) with facing the
needle groove (NO.4) to the front.
1
2
－11－
Insert the system floppy disk printed
[ F1 ] (NO.2) into the disk drive (NO.3)
of the control box.
The system floppy disks are enclosed
in the accessory box.
Turn the power switch (NO.1) ON.
Load
the
system
following the instructions [Method of
PLK-E03BT system installing].
After loading the system software,
keep the system floppy disks with in
care.
software
with
Hide quick links:
Advertisement
Table of Contents
