Toshiba Satellite L300 Maintenance Manual page 128

3.11Error Codes and Description
04 (XMS)Memory Problem
05 (XMS) Out Of Range
06 Address Test Error
07 Toggle Bit Error
08 Interval Error
09 L1 Cache test Error
12 Data Bus Error
14 Speed Error
03xx Board
01 DMA Test Error
04 Interval Timer Error
05 Periodic Faster Error
06 Periodic Slower Error
Update-ended Interrupt
07
Error
08 RTC Alarm Error
13 PCI Bus Error
14 PCI Bus Scan Error
15 PCI Device Access Error PCI access fails.
PCI Config Verification
16
Error
Downloaded from LpManual.com Manuals
The test pattern read out from the
extension memory is different
from the one that has been
written in this address.
Wrong parameters setup.
Interference between different
address channels.
Errors with the timer chip.
The acquired refreshing
frequency is out of the estimated
range.
The pattern read out from the L1
Cache is different from the one
that has been written in the same
address.
Interference between different
data channels.
Failure during the transfer speed
test.
DMA channel cannot transfer
data normally.
The difference between the
actual precision of the interval
timer and its theory value is out
of the permitted range. The timer
counts imprecisely.
The frequency is beyond the
standard.
The frequency is below the
standard.
R/W errors with the RTC
refreshing interrupt controller.
The PC speaker's sound source --
-counter/timer 8253 cannot
produce corresponding timing
signal.
No PCI.
PCI test fails.
Wrong PCI configuration.
Satellite L300D,Satellite Pro L300, EQUIUM L300,SATEGO L300 Maintenance Manual
3 Diagnostic Programs
As above.
Check and reset the parameters.
Test this memory chip on
multiple machines.
As above.
Reset the estimated range.
Test this unit on multiple
machines.
As above.
As above.
Repeat multiple times. Whether
there is always the same error,
replace the board.
As above.
As above.
As above.
As above.
As above.
Check the board.
As above.
As above.
Check PCI configuration on main
board or PCI Device
59