Adjusting The Anti-Scalp Rollers - Toro 74142TE Operator's Manual

Adjusting the Height-of-Cut Pin
Mower-deck size Height-of-cut
range
122 cm (48 inch) 38 to 127 mm
(1-1/2 to 5 inches)
Adjust the height-of-cut from 25 to 140 mm (1 to
5-1/2 inches) in 6 mm (1/4 inch) increments by moving the
clevis pin into different hole locations.
1. Move the transport lock to the L
2. Push on the deck-lift pedal with your foo, and raise the
mower deck to the transport position (also the 140 mm
(5-1/2 inches) height-of-cut position) as shown in
Figure 24.
3. To adjust, rotate the pin 90 degrees and remove the pin
from the height-of-cut bracket
4. Select a hole in the height-of-cut bracket corresponding
to the height-of-cut desired, and insert the pin
24).
5. Push on the deck lift, pull back on the transport lock,
and slowly lower the mower deck.
Figure 24
1. Deck-lift pedal
2. Cut-of-height pin
Increments
6 mm (1/4 inch)
position.
OCK
(Figure 24).
(Figure
3. Transport lock
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, adjust the height
of the anti-scalp rollers.
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the N
and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
1. Anti-scalp roller
2. Spacer
3. Bushing
1. Anti-scalp roller
2. Bushing
23
-
EUTRAL LOCK
g017628
Figure 25
4. Flange nut
5. Bolt
Figure 26
3. Flange nut
4. Bolt
position,
g017629