Servicing The Fuses - Toro 74142TE Operator's Manual

Charging the Battery
WARNING
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks and
flames away from battery.
Important: Always keep the battery fully charged
(1.265 specific gravity). This is especially important to
prevent battery damage when the temperature is below
0°C (32°F).
1. Charge battery for 10 to 15 minutes at 25 to 30 A or
for 30 minutes at 10 A.
2. When the battery is fully charged, unplug the charger
from the electrical outlet, then disconnect the charger
leads from the battery posts
3. Install the battery in the machine and connect the
battery cables; refer to
Note: Do not run the machine with the battery
disconnected; electrical damage may occur.
Figure 52
1. Positive battery post
2. Negative battery post
(Figure 52).
Installing the Battery (page
3. Red (+) charger lead
4. Black (-) charger lead

Servicing the Fuses

The electrical system is protected by fuses. It requires no
maintenance, however, if a fuse blows check the component
and circuit for a malfunction or short.
The fuses are located on the right console next to the seat
(Figure 53).
1. To replace the fuses, pull out the fuse to remove it.
2. Install a new fuse
40).
1. Optional accesory—15 A
2. Charge—25 A
3. PTO—10 A
41
(Figure 53).
G017436
Figure 53
4. Main—25 A
5. Console