Table of Contents
Advertisement
D. Local Port Setup
This screen (see Figure 10) contains settings for configuring the LAN (4-port switch) side of the product,
where your PCs are connected. You can set to distribute IP address to local PCs or not. If "Distribute IP
address to local computer" is selected, users can enter the starting IP address for the group of attached
PCs. The number of IP address decides the total number of clients allowed.
NOTE: All the PCs on the same LAN (switch) should use the same subnet Mask.
Users can also set Static DHCP in this page. Users are allowed to set 32 Static DHCP. Using this feature,
the device will assign the same IP address to a computer (according to the network adapter's MAC
address) and this computer becomes the only one able to request that IP address. This is useful for support
of virtual servers which require fixed IP addresses for outside Internet access.
Private Network
IP Address
Subnet mask
DHCP Server
Do not distribute IP address to local
computers
Distribute IP addresses to local computers
Start IP address
Innovations in Home Living.
Figure 10
Default: 192.168.1.254 (this is the local address of
this On-Q Router/Switch)
Default: 255.255.255.0
Check this radio button to disable this device from
distributing IP Addresses (DHCP Server disabled)
Check this radio button to enable this device to
distribute IP Addresses (DHCP enabled). This enables
the following field for you to enter the starting IP
Address
The starting IP address of this local IP network
address pool. The pool is a piece of contiguous IP
addresses. The default value (192.168.1.1) should
work in most cases.
301 Fulling Mill Road, Suite G
©Copyright 2004 by OnQ Technologies, Inc All Rights Reserved.
Middletown, PA 17057
www.onqhome.com
(800)-321-2343
12
Advertisement
Table of Contents
