Maintenance; Recommended Maintenance Schedule(S) - Toro 22308 Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 8 hours
After the first 50 hours
Before each use or daily
Every 25 hours
Every 50 hours
Every 100 hours
Every 200 hours
Every 250 hours
Every 400 hours
Every 1,500 hours
Yearly or before storage
Important: Refer to your
Note: After the first 8 hours the hour meter displays CHG OIL to remind you to change the hydraulic filter.
Every 99 hours thereafter the screen displays CHG OIL to remind you to change the engine oil. After every
399 hours, the screen displays SVC to remind you to perform the other maintenance procedures based on a 400
hour schedule. These reminders come on starting three hours prior to the service interval time and flash at
regular intervals for six hours.
If you leave the key in the ignition switch, someone could accidently start the engine and seriously
injure you or other bystanders.
Remove the key from the ignition and disconnect the wire from the spark plug before you do any
maintenance. Set the wire aside so that it does not accidentally contact the spark plug.
Maintenance Procedure
• Replace the hydraulic filter.
• Change the engine oil.
• Check and adjust the track tension.
• Check the engine oil level.
• Grease the traction unit. (Grease immediately after every washing.)
• Check the condition of and clean the tracks.
• Remove debris from the traction unit.
• Check for loose fasteners.
• Check the hydraulic fluid level.
• Clean the foam and paper air filter elements. (Service the air cleaner more frequently
if operating conditions are extremely dusty or sandy.)
• Replace the paper air filter element.
• Change the engine oil (more frequently when operating conditions are extremely
dusty or sandy).
• Check the battery electrolyte level (replacement battery only).
• Check the battery cable connections.
• Check and adjust the track tension.
• Check the hydraulic lines for leaks, loose fittings, kinked lines, loose mounting
supports, wear, weather, and chemical deterioration and repair if necessary.
• Check the spark plugs.
• Replace the hydraulic filter.
• Check and grease the road wheels.
• Change the hydraulic fluid.
• Replace all moving hydraulic hoses.
• Check and adjust the track tension.
• Touch up chipped paint
Engine Operator's Manual
for additional maintenance procedures.
24