Error Indicators - Omron HBF-500 Instruction Manual

ERROR DISPLAY

ERROR INDICATORS

CAUSE
Your palms or feet are not positioned
over the electrodes correctly.
The measurement position was not
stable.
Your palms or feet were not placed
correctly.
Feet are too dry.
The Body Composition values are
outside the measurement range.
Your palms or feet are not positioned
over the electrodes correctly.
The monitor is not set up correctly.
You stepped onto the measurement
platform before 0.0 lb was displayed.
The monitor was moved before 0.0 lb
was displayed.
Movement during measurement.
Monitor detected weight over 300.0 lb.
Make sure you are barefoot.
Make sure your palms or the soles of
your feet are clean and dry.
Make sure your feet are correctly
positioned.
Read "How to Take a Measurement"
on page 26.
Remain still and do not move until the
measurement is complete. Read "How
to Take a Measurement" on page 26.
Slightly moisten the soles of your feet
with a damp towel and retake the
measurement.
Check the settings entered for your
personal data. Change the settings
if needed. Retake the measurement.
If this error occurs again and the
settings are correct, measurements
cannot be taken.
Make sure your palms or feet are
correctly positioned.
Remove the batteries. Wait one minute.
Reinstall the batteries. Refer to "Battery
Installation" on page 18.
Press the Power Switch and turn the
monitor on. Retake the measurement.
Wait until 0.0 lb is displayed before
stepping onto the measurement
platform.
Do not move the monitor until 0.0 lb is
displayed.
Do not move until measurement is
complete.
This monitor can only be used by
people weighing less than 300.0 lb.
37
CORRECTION