Getting Started - Lumie Bodyclock Advanced 200 Operating Instructions Manual

English
1 Safety
Keep the glass globe over the bulb, unless the bulb is cold and the
lamp unplugged.
Always use a 60W E14 (SES) candle bulb.
The glass globe will be warm to the touch, so keep it clear of
anything that might deteriorate in contact with heat.
Keep the Bodyclock away from water and damp. For indoor use
only.
Don't open the casing for any reason. There are no user-
serviceable parts inside.
2

Getting started

Remove the 'globe', the glass cover over the bulb, with a gentle
upward tug.
Screw in the bulb firmly and replace the globe.
Find a good position for the Bodyclock close to the bed-head.
Plug the Bodyclock into the mains. The display will flash on and off
until the time has been set.
Once you've programmed the Bodyclock Advanced, all settings
will be memorised if the unit is unplugged or if there's a power
failure. If the power is out for a short period, it will even keep track
of time.
To program the clock A must be depressed (  not lit). Pressing
the P button repeatedly will take you through each of the
programming options in turn (see 19 for the list of options). Within
the next few seconds press
the clock will revert to its normal state if no button is pressed for 12
seconds.
When replacing the bulb, always unplug the Bodyclock. Spare
sunshine neodymium bulbs are available from the Lumie Careline.
4 | www.lumie.com
-
+
or
| lumie careline 0845 658 9292
to change the setting. NOTE: