Kodak i1800 SERIES User Maintenance Manual page 29

Messages
Paused waiting for host
Please update firmware before
scanning
Pod door closed
Pod door opened
Power on self-test completed
Power on self-test failed
Printer bitmap font in use
Rear calibration failed
Rear calibration succeeded
Refeed document set
Requested pages scanned
Paused for image processing
Transport timeout
6-8
ID#
1, 48 The feeder has stopped and the transport is still running
because the scanner's internal image buffer is almost full.
Processing will automatically resume after the capture software
application has successfully retrieved enough images to allow
the scanner to continue.
• Be sure your host computer meets the recommended
specifications to avoid this condition.
91 The expected production version of operational firmware was
not found. The back-up firmware is in use.
• Reload the most recent version of operational scanner
firmware.
26 Informational message. The pod was closed.
25 Informational message. The pod is not closed completely.
20 Informational message. The scanner has completed its self-tests
after power-on.
6 This error could occur during scanner power-up.
• Power-down the scanner, then power down the PC. Wait a few
seconds and then power the PC back up, then power up the
scanner.
• If the problem persists, call Service.
281 Informational message. An alternate printer font file was found
and is being used instead of the default font.
112 The rear imaging path calibration failed.
• Clean the imaging guides. See Chapter 5, Maintenance for
procedures.
• Try to calibrate the scanner again. Be sure you are using the
correct calibration target. See Chapter 3, "Calibrating the
Scanner".
• If the problem persists, call Service.
113 Informational message. The rear image path has been
successfully calibrated.
Many ID Documents passed through the transport but no images were
numbers created.
• Clean document sensors.
• Make sure the leading edges of the documents are aligned.
See Chapter 3, "Document preparation" for more information.
• Check the condition of your feed module and separation roller
tires and your pre-separation pad. Clean and replace if
necessary.
• Refeed these documents and verify that the images have been
captured.
337 Informational message. The scanner has completed scanning
the requested number of documents.
63 Informational message. Scanner paused.
• Slow host PC may not be able to keep up with the scanner.
336 Informational message. The transport was turned off due to
inactivity.
Operator Message
A-61555 May 2010