Safety instructions Índex Dear Customer: Never unplug your hood by pulling the power cable, always by removing the plug Description of the appliance page 4 Thank you for choosing our cooker hood. from the socket. Special requirements before We are sure that appliance you have acquired Never switch the hood on if the electrical feed use for the first time will fully satisfy all your needs.
Description of the appliance These hoods are fitted with The hood in designed in the evacuation of Light-switch gases to the outside, or for his movement Sliding three-speed motor control thrugh carbon filter. The allow that gases can switch retum to the kitchen, purified. Operation indicator light Controllable visor that enables better For place the carbon filter, the anchorage of...
Special Requirements befo- How to use the appliance Suggestions and re using for the first time recommendations Before connecting the hood to the electricity • Switch on the extractor fan a few Motors mains, make sure that the mains voltage and minutes before you start to cook (3 frequency correspond to the values indicated to 5 minutes) in order to ensure that...
Cleaning and maintenance BIFORE CLEANING AND MAINTENANCE, BE Cleaning the grill and ventilator Changing the light-bulbs Cleaning the filter support SURE THAT THE APPLIANCE IS DISCONNEC- and the hood body TED FROM THE MAINS SUPPLI. Wait for the motor to cool before carrying out •...
Possible causeSolution The hood doesn’t work Made in European Community- C.I.F.: A-39004932 Mains cable not connected Connect mains cable Nº. de fabric. MOD. CS-6000 89-555551 Power not reaching plug Check/repair mains supply Fabrík.-Nr. TYP. S-622325 Serial Nº Hood not extracting POTENCIA NOM.
Installation Before installing the hood, consult the require- The lower part of the hood should be placed ments of the appropriate authorities concer- at a minimum height of 60 cm above the hob ning air and smoke extraction regulations. for electric cookers and 70 cm for gas coo- kers.
Re-circulation through Replacing the mains cable Extraction through the upper part (A) active carbon • Ensure that the hood is disconnected The system requires an outlet conduit. Place the lever situated in the casing in the from the mains supply. position <<I>>, ensuring that the round cover The gas extraction lever should be set in the is placed over the opening (A).
Need help?
Do you have a question about the CS-6000 and is the answer not in the manual?
Questions and answers