Handling Errors And Problems; Error Messages - Omron M3 Intellisense Instruction Manual

5. Handling Errors and Problems

5.1

Error Messages

Error Display
Blinks or appears
continuously
Cause
Cuff is under inflated.
Movement during
measurement
Air plug disconnected.
Arm cuff not applied
correctly.
Clothing is interfering with
the arm cuff.
Air is leaking from the arm
cuff.
The arm cuff was inflated
above 299 mmHg when
inflating the cuff manually.
Battery power is low.
5.Handling Errors and Problems
Remedy
Carefully read and repeat the steps
listed under section 3.4.
Repeat measurement. Remain still
and do not talk during
measurement.
Refer to section 3.3.
Insert the air plug securely.
Refer to section 3.2.
Apply the arm cuff correctly.
Refer to section 3.2.
Remove any clothing interfering
with the arm cuff.
Refer to section 3.2.
Replace cuff with new one.
Refer to Chapter 7.
Release your finger from the O/I
START button before the pressure
reaches 299 mmHg, when inflating
the cuff manually.
Refer to section 3.4.
Replace all four "AA" batteries with
new ones.
Refer to section 2.1.
EN
27