Select Switch On Remote Controller - Toshiba RAS-M13PKVP-E Service Manual

Item
17. Select switch on
remote controller
Push the operation button
on the remote controller.
Both indoor units
start operation.
NO
Unnecessary set
[Remote controller select]
Cutting direction
Operation fl ow and applicable data, etc.
Select "B" as the setting for
YES
one of the two indoor units and
for the remote controller.
(See below for details.)
Setting the remote controller
Switching between A and B is enabled by cutting the jumper wire inside
the battery box using pliers.
1) Slide open the remote controller cover and remove the batteries.
2) Cut the jumper wire inside the battery compartment using nippers.
•
Jumper wire
3) Insert the batteries. "B" appears in the remote controller display.
* Even after the jumper wire has been cut, switching between A
* When switching between settings "A" and "B", always switch the
4) Push the RESET button (Indoor unit) to start automatic operation.
5) Push the
stop the air conditioner.
(This operation will change the setting to "B".)
6) Check that the remote controller operates the indoor unit.
1. Purpose
This operation is to operate only one
indoor unit using one remote controller.
2. Description
When operating one indoor unit in a
situation where two indoor units have
been installed in the same room or
nearby rooms, this operation prevents
the remote controller signal from
being received simultaneously by both
units, thus preventing both units from
operating.
3. Operation
The indoor unit on which the remote
controller selection has been set to
B receives the signal of the remote
controller also set to B.
(At the factory the remote controller
selection is set to A on all the indoor
units. There is no A setting display.)
The jumper wire should not remain in contact after being cut.
Also, be careful not to let plastic scraps, jumper wire cuttings or
other debris enter the inside of the remote controller.
and B is still possible by pushing the CHECK button and FIX
button together.
The A or B setting, which was switched by pushing the CHECK
button and FIX (▲/▼) button together, is restored to the setting
established prior to the switching when the battery is replaced or
the RESET button is pushed.
indoor unit board and the remote controller as a pair. (Otherwise,
the indoor unit will not accept the remote controller's signals.)
button of the remote controller that was set in step 1 to
– 45 –
Description