Select Switch On Remote Controller; Setting The Remote Controller - Toshiba RAS-M10PKVP-E Service Manual

Item
18. Select switch on
remote
controller
Push the operation button
on the remote controller.
Both indoor units
start operation.
NO
Unnecessary set
[Remote controller select]
Cutting direction
Operation flow and applicable data, etc.
Select "B" as the setting for
YES
one of the two indoor units and
for the remote controller.
(See below for details.)

Setting the remote controller

Switching between A and B is enabled by cutting the jumper wire inside the
battery box using pliers.
1) Slide open the remote controller cover and remove the batteries.
2) Cut the jumper wire inside the battery compartment using nippers.
• The jumper wire should not remain in contact after being cut. Also, be
Jumper wire
3) Insert the batteries. "B" appears in the remote controller display.
∗ Even after the jumper wire has been cut, switching between A and B
∗ When switching between settings "A" and "B", always switch the indoor
4) Push the RESET button (Indoor unit) to start automatic operation.
5) Push the
the air conditioner.
(This operation will change the setting to "B".)
6) Check that the remote controller operates the indoor unit.
1. Purpose
This operation is to operate only one indoor
unit using one remote controller.
2. Description
When operating one indoor unit in a
situation where two indoor units have been
installed in the same room or nearby rooms,
this operation prevents the remote controller
signal from being received simultaneously
by both units, thus preventing both units
from operating.
3. Operation
The indoor unit on which the remote
controller selection has been set to B
receives the signal of the remote controller
also set to B.
(At the factory the remote controller
selection is set to A on all the indoor units.
There is no A setting display.)
careful not to let plastic scraps, jumper wire cuttings or other debris
enter the inside of the remote controller.
is still possible by pushing the CHECK button and FIX button together.
The A or B setting, which was switched by pushing the CHECK button
and FIX (5 / ) button together, is restored to the setting established
prior to the switching when the battery is replaced or the RESET button
is pushed.
unit board and the remote controller as a pair.
(Otherwise, the indoor unit will not accept the remote controller's
signals.)
button of the remote controller that was set in step 1 to stop
– 73 –
Description