Table of Contents
Advertisement
4. Refer to the table below to interpret the LED indicators
on the battery charger.
LED COLOR
Left
Right
Red
Red
Red
Green
Red
Orange
Inserting the Battery into the
Product
1. Align the tongue of the battery pack with the cavity in
the handle housing
1
Hedge trimmer handle shown
1. Cavity
2. Tongue
Indicates:
Battery is charging
Fully charged
Battery is too
warm: Remove
for approximately
30 minutes
(Figure
3).
2
G016329
Figure 3
3. Latch
2. Grasp the product handle.
3. Push the battery pack into the handle until the latch
locks into place.
Important: The battery pack is not fully charged
when it is purchased. Before using the battery for
the first time, refer to
(page
3). Make sure to read all safety precautions.
If storing for a prolonged period of time, remove
the battery. When ready to use again, charge the
battery pack; refer to
(page
3).
Battery Pack Preparation For
Recycling
WARNING
Upon removal, cover the battery pack's terminals
with heavy-duty adhesive tape. Do not attempt to
destroy or disassemble the battery pack or remove
any of its components. Lithium-ion batteries must
be recycled or disposed of properly at the nearest
battery recycling facility.
3
Troubleshooting
Using the battery when it is hot can reduce the operating
time. The battery will automatically stop working when it
is overheated to prevent damage to it. Remove the battery
from the charger and allow it to cool before placing it back
into the product.
Using the battery when there is moisture on the leads can
cause the trimmer to malfunction. Allow the battery to dry or
wipe it dry before placing it back into the product.
4
Charging the Battery Pack
Charging the Battery Pack
Advertisement
Table of Contents
